Features of your vehicle
114
Wipers and washers
䳜 8hen starting the vehicle in win
-
ter, set the wiper switch in the off
position. Otherwise, wipers may
operate and ice may damage the
windscreen wiper blades. Always
remove all snow and ice and
defrost the windscreen properly
prior to operating the windscreen
wipers.
Windscreen washers (front)
Type A
Type B
In the O (OFF) position, pull the lever
gently toward you to spray washer
fluid on the windscreen and to run
the wipers 1-3 cycles.
Use this function when the wind
-
screen is dirty.
The spray and wiper operation will
continue until you release the lever.
If the washer does not work, check
the washer fluid level. If the fluid
level is not sufficient, you will need
to add appropriate non-abrasive
windscreen washer fluid to the
washer reservoir.
The reservoir filler neck is located in
the front of the engine compart
-
ment on the driver side.
To prevent possible damage to the
washer pump, do not operate the
washer when the fluid reservoir is
empty.
Do not use the washer in freezing
temperatures without first warming
the windscreen with the defrosters;
the washer solution could freeze on
the windscreen and obscure your
vision.
䳜 To prevent possible damage to
the wipers or windscreen, do not
To Next Page
Loading...
