13
3
3
Safety features of your vehicle Seats
2. Set the front seatback to the
upright position and if necessary,
slide the front seat forward.
3. Lower the rear headrests to low
-
est position.
4. Pull the lock release lever and fold
the rear seatback forward and
down firmly.
To unfold the rear seat
1. To use the rear seat, lift and pull
the seatback backward. Pull the
seatback firmly until it clicks into
place. Make sure the seatback is
locked in place. When you return
the seatback to its upright posi
-
tion, always be sure it has locked
into position by pushing on the
top of the seatback.
If you can not see the red line at
the bottom of folding lever, it
means the seatback is locked
completely.
2. 3eturn the rear seat belt to the
proper position.
3. When the seatback is completely
installed, check the seatback fold
-
ing lever again.
Uprighting seat
When you return the seatback to its
upright position, hold the seatback
and return it slowly. If the seatback
is returned without holding it, the
back of the seat could spring for
-
ward resulting in injury caused by
being struck by the seatback.
After folding the rear seat, unless
the driver䳓s position is properly set
according to the driver䳓s physical
figure, do not fold the rear seat. It
may increase body injuries in a sud
-
den stop or collision.
To Next Page
Loading...
