Driving your vehicle
1005
Blind-Spot Collision-Avoidance Assist (BCA)
applied. If a trailer, carrier, etc. is
installed, it may adversely affect
the performance of the rear cor
-
ner radar or the function may not
operate.
For more details on the precautions
of the front view camera, refer to
"Forward Collision-Avoidance Assist
(FCA) (Sensor fusion) (if equipped)"
on page -66.
Function settings
Setting
Blind-Spot Safety
8ith the ignition switch or ENGINE
STA3T/STOP button in the ON posi
-
tion, select or deselect 䳒Driver assis
-
tance → Blind-spot safety䳓 from the
User Settings menu to set whether
or not to use each function.
䳜 If 䳒Active assist䳓 is selected, the
function will warn the driver with
a warning message, an audible
warning and braking assist will be
applied depending on the collision
risk levels.
䳜 If 䳒8arning only䳓 is selected, the
function will warn the driver with
a warning message, an audible
warning depending on the collision
risk levels. Braking will not be
assisted.
䳜 If 䳒Off䳓 is selected, the function will
turn off.
8hen the engine is restarted with
the function off, the 䳒Blind-Spot
Safety System is Off䳓 message will
appear on the cluster.
If you change the setting from 䳒Off䳓
to 䳒Active assist䳓 or 䳒8arning only䳓,
the warning light on the outside
rearview mirror will blink for three
seconds.
In addition, if the engine is turned
on, when the function is set to
䳒Active assist䳓 or 䳒8arning only䳓, the
To Next Page
Loading...
