105
5
5
Driving your vehicle Blind-Spot Collision-Avoidance Assist (BCA)
Function disabled
8hen the rear bumper around the
rear corner radar or sensor is cov
-
ered with foreign material, such as
snow or rain, or installing a trailer or
carrier, it can reduce the detecting
performance and temporarily limit
or disable Blind-Spot Safety sys
-
tem.
If this occurs, the 䳒Blind-spot safety
systems disabled. 3adar blocked䳓
warning message will appear on the
cluster.
The function will operate normally
when such foreign material or
trailer, etc. is removed, and then the
engine is restarted.
If the function does not operate
normally after it is removed, have
the vehicle inspected by a profes
-
sional workshop. Kia recommends to
visit an authorised Kia dealer/ser
-
vice partner.
Even though the warning message
does not appear on the cluster,
Blind- Spot Safety system may not
properly operate.
Blind-Spot Safety system may not
properly operate in an area (e.g.
open terrain), where any substance
are not detected right after the
engine is turned on, or when the
detecting sensor is blocked with
foreign material right after the
engine is turned on.
Turn off Blind-Spot Safety system
to install a trailer, carrier, etc., or
remove the trailer, carrier, etc. to
use Blind-Spot Safety system.
-imitations of the function
Blind-Spot Safety system may not
operate normally, or the function
may operate unexpectedly under
the following circumstances:
䳜 There is inclement weather, such
as heavy snow, heavy rain, etc.
䳜 The rear corner radar is covered
with snow, rain, dirt, etc.
䳜 The temperature around the rear
corner radar is high or low
䳜 Driving on a highway (or motor
-
way) ramp
䳜 The road pavement (or the
peripheral ground) abnormally
To Next Page
Loading...
