Driving your vehicle
1105
Manual Speed -imit Assist (MS-A)
The set speed limit will be displayed
on the cluster.
To drive over the preset speed limit
you must depress hard on the
accelerator pedal (more than
approximately 80%) until the kick
down mechanism works with a
clicking noise. Then the set speed
limit will blink and chime will sound
until you return the vehicle speed
within the speed limit.
䳜 Depressing the accelerator pedal
less than approximately 0%, the
vehicle will not speed over the
preset speed limit but maintain
the vehicle speed within the speed
limit.
䳜 A clicking noise heard from the
kick down mechanism by
depressing the accelerator pedal
fully is a normal condition.
To turn off the speed limit control,
do one of the following:
䳜 Press the Driving Assist button
once again.
䳜 Press the Driving Assist button (If
you press the Driving Assist but
-
ton, the cruise function will turn
on)
If you press the O button once, the
set speed limit will cancel, but it will
not turn the function off. If you wish
to reset the speed limit, move the
switch up (to 3ES+) or down (to
SET-) to the desired speed.
To Next Page
Loading...
