17
6
6
What to do in an emergency If you have a flat tyre (with spare tyre)
7. Place the jack at the front (1) or
rear (2) jacking position closest to
the tyre you are changing. Place
the jack at the designated loca
-
tions under the frame. The jack
-
ing positions are plates welded to
the frame with two tabs and a
raised dot to index with the jack.
+ack location
To reduce the possibility of injury,
be sure to use only the jack provided
with the vehicle and in the correct
jack position; never use any other
part of the vehicle for jack support.
8. Insert the jack handle into the jack
and turn it clockwise, raising the
vehicle until the tyre just clears
the ground. This measurement is
approximately 30 mm (1.2 in).
Before removing the wheel lug
nuts, make sure the vehicle is sta
-
ble and that there is no chance for
movement or slippage.
To Next Page
