Kobold VK200 - User Manual

Questions and Answers

K
kayla64Aug 27, 2025
Why does my Kobold VK200 Vacuum Cleaner change power levels and get louder on its own?
- L
  Larry MooneyAug 27, 2025
  Your Kobold Upright Vacuum Cleaner might change power performance levels and get louder due to overheating. This can happen after prolonged use, in high ambient temperatures, or if the 3in1 Premium Filterbag is full or blocked. Check the suction channel and connected accessory heads for blockages, and replace the 3in1 Premium Filterbag if needed. Allow the motor to cool down. This can also be the result of switching from hard floors to carpeting or when using power performance level auto (automatic suction power).
D
Danielle CalhounAug 26, 2025
Why does my Kobold Automatic Electric Brush keep turning off and flashing red?
- K
  Karen HenryAug 27, 2025
  If the Automatic Electric Brush switches itself off and the operating display flashes red, it could be because: * A vacuumed object is blocking the brush. Switch the device off, unplug it, and remove the object. * Threads are blocking the brush.
M
mark13Aug 25, 2025
Why does my Kobold VK200 smell bad?
- J
  Jackie ClarkAug 26, 2025
  An unpleasant odor from your Kobold Upright Vacuum Cleaner could mean the 3in1 Premium Filterbag FP200 has lost its ability to retain odors, even if it's not full. Exchange the 3in1 Premium Filterbag and insert a new Dovina fragrance chip. Also, thoroughly clean the suction channel of the Upright Vacuum Cleaner and/or the connected device, as well as the motor protection filter.
W
williamhawkinsAug 25, 2025
What to do if my Kobold VK200 doesn’t run and the LEDs flash red?
- C
  Carla BurgessAug 25, 2025
  If your Kobold Vacuum Cleaner doesn’t run and the LEDs flash red, the issue could be due to a few reasons: * During the initial setup, the telescopic handle may not have been mounted correctly, preventing an electrical connection. Pull out the mains plug, extend the handle again until it locks into place. * The device may have overheated. Pull out the mains plug, let the device cool down, and try again.