- 6 -
FOR YOUR SAFETY
POWER SUPPLY
Use the proper voltage. Otherwise it will result in fire or electrical shock.
Turn on/off the power by ON/OFF keys on the Operation unit.
Turning on/off the power by the switchboard may damage the unit.
Turn off the power when starting the ship engine.
Otherwise it may damage the unit.
HANDLING
Do not operate the unit while steering.
Otherwise it will cause wrecks.
Do not open the case cover.
There is a risk of electrical shock if you touch the high voltage
conductors.
Only qualified personnel should work inside the unit.
Care for sufficient reinforcement and being watertight should be taken
when installing the Hull unit.
Otherwise it will cause wrecks.
Use the proper fuse when changed.
Otherwise it could result in serious trouble or fire.
Use the specified power supply cables.
Otherwise it could result in serious trouble or fire.
The Hull unit Gears and Flange Unit need a regular lubrication with
grease.
Confirm the voltage between the Flang and the minus terminal of the ship’s battery does not
exceed 0.65 volts after the installation completed.
Use the larger diameter cable if the voltage exceeds 0.65 volts.
Otherwise the damage to the Transducer unit due to the electrolytic corrosion may results.
To Next Page
Loading...