S748-772 Instructions Manual | 5 Approvals
5.2 CE conformance
The servo amplifiers have been tested by an authorized testing laboratory in a defined con-
figuration, using the system components that are described in this documentation.
Any divergence from the configuration and installation described in this documentation
means that you will be responsible for carrying out new measurements to ensure con-
formance with regulatory requirements.
Kollmorgen declares the conformity of the products S748 and S772 with the following dir-
ectives
EC Machinery Directive 2006/42
EC EMC Directive 2014/30/EC
EC Low Voltage Directive 2014/35/EC
Concerning noise immunity the servo amplifier meets the requirements to the 2nd envir-
onmental category (industrial environment). For noise emission the amplifier meets the
requirement to a product of the category C2 (motor cable up to 10 m). With a motor cable
length from 10 m onwards, the servo amplifier meets the requirement to the category C3.
This product can cause high-frequency interferences in non industrial environments which
can require measures for interference suppression.
5.2.1 European Directives and Standards for the machine builder
Servo amplifiers are safety components that are intended to be incorporated into electrical
plant and machines for industrial use. When the servo amplifiers are built into machines or
plant, the amplifier must not be used until it has been established that the machine or equip-
ment fulfills the requirements of the
EC Machinery Directive (2006/42/EC)
EC EMC Directive (2014/30/EC)
EC Low Voltage Directive (2014/35/EC)
Standards to be applied for conformance with EC Machinery Directive (2006/42/EC)
IEC 60204-1 (Safety and Electrical Equipment in Machines)
ISO 12100 (Safety of Machines)
The manufacturer of the machine must generate a risk assessment for the machine, and
must implement appropriate measures to ensure that unforeseen movements cannot cause
injury or damage to any person or property.
The machine manufacturer must check whether other standards or EC Directives must be
applied to the machine.
Standards to be applied for conformance with EC Low Voltage Directive(2014/35/EC)
IEC 60204-1 (Safety and Electrical Equipment in Machines)
IEC 60439-1 (Low-voltage switchgear and controller assemblies)
Standards to be applied for conformance with EC EMC Directive (2014/30/EC)
IEC 61000-6-1 / 2 (Interference Immunity in Residential & Industrial Areas)
IEC 61000-6-3 / 4 (Interference Generation in Residential & Industrial Areas)
The manufacturer of the machine is responsible for ensuring that it meets the limits required
by the EMC regulations. Advice on the correct installation for EMC can be found in this doc-
umentation.
We only guarantee the conformance of the servo system with the standards cited in this
chapter if the components (motor, cables, chokes etc.) are those supplied by us.
22 Kollmorgen | kdn.kollmorgen.com | July 2019
To Next Page
Loading...
Need help?
General
