Konica Minolta MS7000 MK II - Replacing the Projection Lens

3
Scanner
3-23
3.10 Replacing the Projection Lens
1
Take hold of the Prism
Holder Lever and push it up
to raise the Prism Holder.
2
Pull out the Projection Lens
Unit towards the front of the
Scanner.
3
Slide the new Projection
Lens Unit all the way into the
Scanner along the Lens
Holder Guide.
When the Projection Lens Unit is slid into position, the Scanner
automatically selects the optimum screen brightness according to the type
of lens being used.