92
own insert effect or AUDIO OUTPUT (INDIVID-
UAL) jack 1–2.
For example you might set snare-type sounds to
IFX1 and kick sounds to IFX2, so that these sounds
would be sent to insert effects 1 and 2 respectively. If
you wish to send only specific drumsamples to
AUDIO OUTPUT (INDIVIDUAL) jacks 1, 2, select
1,2 or 1/2.
These settings are valid if “Use DKit Setting” (PROG
7.1: Ed-BUS, BUS page) is checked for the program
that uses this drum kit (
☞PG p.37, 161).
C Use “Pan” to specify the stereo output position.
The setting you make here is valid if the “Use DKit
Setting” is checked (PROG 5.1: Ed-Amp1, Level/
Pan page) for the program that uses this drum kit.
D Use “S1 (Send1(MFX1))” and “S2 (Send2(MFX2))”
to set the send levels to the master effects.
The settings you make here are valid if the “Use
DKit Setting” is checked (PROG 7.1: Ed-BUS, BUS
page) for the program that uses this drum kit.
E Use the “Write Drum Kits” utility to save the data.
If you wish to change the name of the drum kit
before you save it, use the “Rename Drum Kit” util-
ity (☞p.39).
If you turn off the power before writing the data into
memory, your edits will be lost (☞p.40 “Memory in
Global mode”).
To Next Page
Loading...
