An overview of Sequencer mode
127
• To: Drum Track set to Track 10
• Check Recording Setup Multi REC
• Check REC for tracks 01 and 10
5. The M50 will automatically enter record-ready mode,
and the metronome will sound according to the Metro-
nome setting (Seq 0–1–8b).
6. Press the START/STOP switch to begin realtime record-
ing. To stop recording, press the START/STOP switch
once again.
The Compare function
When you perform realtime recording, step recording, or
track editing, this function allows you to make before-and-
after comparisons.
If you continue editing when the COMPARE switch is lit,
the switch will go dark. This now becomes the musical data
that will be selected when the COMPARE switch is dark.
Operations for which Compare is available
In general, track and pattern event data can not be returned
to its original state.
Comparing song parameters is possible only during song
editing (when executing a menu command).
• Recording to a MIDI track
• Track Edit
All commands except for the menu commands Memory
Status, Exclusive Solo, FF/REW Speed and Set Location
of the P6: Track Edit– Track Edit page.
• Recording to a pattern
• Pattern Edit
All commands except for the menu commands Memory
Status, Exclusive Solo, Convert to Drum Trk Pattern,
Erase Drum Track Pattern, and FF/REW Speed of the
P10: Pattern/RPPR– Pattern Edit page.
• Song Edit
P0–P5 pages: menu commands Delete Song and Copy
From Song
The program will not be affected by the Compare, and
will not return to its prior state.
Operations for which Compare is not available
• Editing song parameters
•Menu commands other than those listed under
“Operations for which Compare is available,” above.
To Next Page
Loading...
