Sequencer mode
136
These settings include the parameters assigned to each
slider and switch in the display, along with the on/off state
assigned to Absolute parameters.
The resulting effect of Tone Adjust settings that were saved
in Program mode is saved with the program, regardless of
the “Auto Load PCG” setting. The program will sound
according to its settings, regardless of whether Tone Adjust
settings were saved.
Once the Program has been loaded, you can change any or
all of the Tone Adjust settings as desired. All such edits are
stored in the Song, without affecting the original Program.
If Auto Load PRG is On, Tone Adjust settings will be
automatically loaded along with the Program.
If Auto Load PRG is Off, the Tone Adjust settings of the
program will not be loaded; the program settings prior to
editing the Tone Adjust settings will remain.
Selected parameter information
This status line shows detailed, read-only information about
the currently selected Tone Adjust parameter.
Control [SW1…8, SL1…8]
This is the switch or slider in the display that is assigned to
Tone Adjust parameters.
Assignment [List of Tone Adjust assignments]
This is the full name of the parameter assigned to the switch
or slider in the display. You can change this using the
“Assign” parameter, below.
Value
This shows the current value of the parameter. The range of
values will vary depending on the parameter assigned to the
switch or slider.
Type [Rel, Abs, Meta]
This shows the type of the parameter, which relates to how
edits to the parameter are saved. For more information,
please see “Absolute (Abs), Relative (Rel), Meta parameter”
on page 6.
Stored Value
This shows the original value of the parameter, before the
effects of Tone Adjust. It applies only to Tone Adjust
parameters which control a single Program parameter.
If you un-assign a parameter from a control, it will revert to
this value.
0–1–7c: Tone Adjust
Here, you can assign Tone Adjust parameters to the switches
and sliders in the display.
Switches 1...8
Tone Adjust switches act a little differently than sliders in
the display.
When a switch is assigned to a Relative parameter, or an
Absolute parameter with more than two states:
Switch On = On Value (see below)
Switch Off = the Program’s stored value
When a switch is assigned to a two-state Absolute
parameter, such as Hold, the switch status directly reflects
the parameter value:
Switch On = On
Switch Off = Off
Assign
This assigns Tone Adjust parameters to the switches in the
display. For a full list of the available choices, please see
“Common Tone Adjust Parameters” on page 8 and “Tone
Adjust Parameters” on page 9.
On Value [Depends on parameter]
The parameter is set to this value when the switch is On.
When the switch is assigned to a two-state Absolute
parameter, such as Hold, this will always be the same as the
Switch Status (see below).
Switch Status [Off, On]
This simply shows whether the switch is On or Off.
Sliders 1–8
Assign
This assigns Tone Adjust parameters to the sliders in the
display. For a full list of the available choices, please see
“Common Tone Adjust Parameters” on page 8 and “Tone
Adjust Parameters” on page 9.
Assignments are exclusive
Per-Oscillator parameters apply to OSC1 and 2 individually,
and are marked as such: OSC1 and OSC2.
Each slider can be assigned to only one parameter, and each
parameter can be assigned to only one slider.
To swap a parameter from one slider to another, you’ll need
to first un-assign it from the old slider, and then assign it to
the new slider.
Value
This shows the current value of the parameter. The range of
values will vary depending on the parameter assigned to the
control.
Control Assignment Value Stored ValueType
Assign
On/Off
Value
To Next Page
Loading...
Need help?
General
