Korg microKORG2 - Page 101

microKORG2 EFFECT, EQ section - Modulation (MOD)
101
2. Wave [Triangle, Square, Saw, Sine, Sample & Hold]
This sets the type of waveform that will modulate the amplitude of the input signal.
3. Speed [“Bpm Sync” Off: 0...127 / “Bpm Sync” On: 1/1, 3/4, 1/2, 3/8, 1/3, 1/4, 3/16, 1/6, 1/
8, 3/32, 1/12, 1/16, 1/24, 1/32, 1/64] (CC#12)
Adjusts the rate of the modulation effect, depending on the range of the selected subtype. Turning
the knob to the right will increase how fast the effect modulates the input signal.
4. Depth [0...127] (CC#111)
This sets the intensity of the effect. Turning the knob to the right will increase the intensity.
MOD EXTRA
1. Mode [Normal, Harmonic]
Switches between normal tremolo and harmonic tremolo.
Harmonic tremolo splits the input sound into high and low frequency bands and modulates the vol-
ume of each band to create a unique tremolo effect.
2. Shape [0...127]
Sets the intensity of the processing done to the internal LFO. For Triangle, Saw, and Sine, turning the
knob to the right makes the LFO curve more exponential. For Square and S&H, turning the knob to
the right increases the amount of smoothing applied to the LFO output.
3. BPM Sync (BpmSync) [Off / On]
Switches the speed parameter between absolute frequency in hz and tempo synced subdivisions.
4. Inversion (Inv) [Positive, Negative]
Sets the polarity of the internal LFO.
5. Width [0...127]
Sets the stereo spread of the effect. Turning the knob to the right will increase the width of the stereo
field.
LoFi
An effect that wobbles and distorts like an old record or tape player.
MOD
1. Effect Type (Type) LoFi
2. LoFi SubType (SubType) [33.3 rpm, 45.0 rpm, 78.3 rpm]
Selects one of the available sub types.
3. Wow Depth (Wow) [0...127] (CC#12)
This sets the intensity of the effect. Turning the knob to the right will increase the intensity.
4. Isolation (Iso) [0...127] (CC#111)
Sets the intensity of the isolator filter. Turning the knob to the right reduces the range of frequencies
passed by the filter.
5. Saturation (Satu) [0...127] (CC#112)
Sets the intensity of the non-linear processing. Turning the knob to the right increases the amount of
harmonic distortion.