Korg microKORG2 - Page 104

microKORG2 EFFECT, EQ section - Modulation (MOD)
104
Amp Simulator
An effect that emulates the distortion and timbre of a guitar amp.
MOD
1. Effect Type (Type) Amp Simulator
2. AmpSim Model (Model) [Clean, Vintage, Crunch, Dark, Hard, Heavy]
Selects the type of amp model.
3. Tone [0...127] (CC#12)
Cuts the high frequency content of the distorted signal. Turning the knob to the left makes the signal
darker.
4. Depth [0...127] (CC#111)
Sets the intensity of the effect. Turning the knob to the right makes the effect more intense.
5. Output [-24...6] (CC#112)
Adjusts the output volume. The output range is from -24 dB to +6 dB.
MOD EXTRA
2. Pre EQ Freq (EqFreq) [0...127]
Sets the cutoff of the peaking EQ that processes the input to the amp sim. Turning the knob to the
right increases the frequency.
3. Pre EQ Gain (EqGain) [-63...0...63]
Sets the gain of the peaking EQ that processing the input to the amp sim. Turning the knob right of
center increases the boost, while turning the knob left of center increases the cut.
4. Post Low Cut (LowCut) [0...127]
Sets the cutoff frequency of the high pass filter that processes the output of the amp sim. Turning the
knob right increases the cutoff frequency.
5. Dry/Wet [0...100 %]
This sets the mix of the unprocessed (dry) and processed (wet) signals. Turning the knob to the right
will increase the wet level and decrease the dry level.