Korg microKORG2 - Page 110

microKORG2 EFFECT, EQ section - REVERB
110
5. Damping (Damp) [0...127](CC#117)
Sets the cutoff frequency of the damping filter. Turning the knob to the right reduces the amount of
high frequency content.
REVERB EXTRA
2. PreDelay [0...127]
Sets the amount of time between the reverb receiving a signal and producing an output signal. Turn-
ing the knob to the right increases the delay between input and output.
3. Width [0...127]
Adjusts the stereo image of the reverb. Turning the knob to the right creates a wider stereo image.
4. Size [0...127]
Changes the internal delay times to create the impression of different sized spaces. Turning the knob
to the right will increase the perceived size of the space.
5. Dry/Wet [0...100 %]
Adjusts the mix of the dry and wet signals relative to each other. Turning the knob to the right will
decrease the input signal mix and increase the reverb output mix.