microKORG2 EFFECT, EQ section - EQ
112
EQ
|
EQ
The output from the effects is routed through the equalizer (EQ), the last stage in the effect signal
chain for adjusting the tonal character.
The EQ is used to adjust the tonal balance, such as by bringing muddy sounds forward in the mix or
by toning down sounds that stand out too much.
•
Press the EQ button while holding down the ON/OFF button to turn the equalizer on/off (the LED below
the button lights up when the equalizer is on).
•
Use the Frequency (knobs 1 and 3) to set the frequencies to adjust, and use the Gain (knobs 2 and 4) to set
the gain for each frequency.
Note:
Excessively raising the equalizer gain may make the output sound distorted.
1. Low Frequency (Low Freq) [40...1000 Hz] (CC#95)
Sets the frequency of the low-range equalizer.
2. Low Gain [-63...0...63] (CC#110)
Sets the amount of boost or cut for the low-range equalizer.
3. High Frequency (High Freq) [1.0...18.0 kHz] (CC#94)
Sets the frequency of the high-range equalizer.
4. High Gain [-63...0...63] (CC#109)
Sets the amount of boost or cut for the high-range equalizer.
5. Output Feedback (Feedback) [-63...0...63] (CC#93)
Sets how much of the output from the EQ you want to feed back into the EQ input. A negative value
inverts the phase of the signal that’s fed back.
To Next Page
Loading...
