microKORG2 Part names - Rear panel
17
9 Mic holder
Mount the included mic onto this holder.
10 MIDI IN, OUT connectors → Connecting to a MIDI device
These connectors allow the microKORG2 to exchange MIDI messages with an external MIDI
device.
11 Grounding screw
Use this terminal (screw) to connect the microKORG2 to a ground terminal. To connect, loosen the
terminal and use a grounding wire to attach it to the ground terminal. After loosening the termi-
nal (screw), be sure to tighten it again.
To avoid malfunctions, make sure the cable that you use to connect the following jacks is no
more than 3 m long.
AUX IN jack, CONDENSER jack, DYNAMIC jack, headphones jack, DAMPER/SWITCH jack, USB
port
To Next Page
Loading...
