Korg microKORG2 - Page 56

microKORG2 TIMBRE EDIT section - OSC 1, OSC 2, OSC 3, NOISE
56
When Wave is “Saw”: You can modify the waveform by adjusting this value. A setting of 0 produces a
sawtooth wave, and a setting of 127 produces a sawtooth wave one octave higher.
When Wave is “Square”: This value sets the pulse width. A setting of 0 produces a pulse width of
50% (square wave), and a setting of 127 produces a pulse width of 0% (no sound). The sound
becomes “harder” as the value approaches 0%.
When Wave is “Triangle”: You can modify the waveform by adjusting this value. A setting of 0 pro-
duces a basic triangle wave, and a setting of 127 produces a waveform with a pitch that is one octave
and a fifth higher.
When Wave is “Sine”: A value of 0 produces a pure sine wave, and a setting of 127 produces a
slightly distorted “fat” sine.
When Wave is “DWGS”: Changing the value selects a sampled waveform.
→ DWGS
When Wave is “OneShot”: Changing the value selects a sampled waveform.
→ Oneshot
3. OSC Mod Amount (OSC Mod) [Off, 1...127] (CC#15)
Sets how much modulation from oscillator 3 is applied to the sound of oscillator 1.
4. Semitones [-24...0...24] (CC#16)
Adjusts the pitch of oscillator 1 in semitones (100 cent) steps. A value of ±12 produces a difference of
±1 octave, and a value of ±24 produces a difference of ±2 octaves.
5. Fine Tune [-50...0...+50 Cent] (CC#17)
Sets the pitch of the oscillator in one-cent steps. The range is ±50 cents.