FX page |97
English
Parameters Values Notes
Time 1…100 Sets the reverb time.
Size 5…100 Sets the size of the space.
Damping 0…100 This sets the cutoff of the high-frequency damping filter.
If Damping is set to 100, the high frequencies will decay at
the same rate as the low frequencies; at 0, the high fre-
quencies will decay almost instantly.
Rolloff 0…100 This controls a lowpass filter on the output of the effect.
Settings around 6-8kHz are good for producing a warm,
smooth sound.
Pre Delay 0…1360 Sets the initial delay before the reverberation begins. By
adjusting this setting you can clarify the definition of the
original sound.
Mix 0…100 Adjusts the mix between the direct signal and the effect.
Spring
This models the spring reverb system used in some guitar and vintage organ
amps.
Parameters Values Notes
Time 0…99 Sets the reverb time.
Lo Damp 0…100 Adjusts the attenuation of the low-frequency range.
Hi Damp 0…100 Adjusts the attenuation of the high-frequency range.
Pre Delay 0…70 Sets the initial delay before the reverberation begins. By
adjusting this setting you can clarify the definition of the
original sound.
Mix 0…100 Adjusts the mix between the direct signal and the effect.
To Next Page
Loading...
Need help?
General
