Kurzweil PC3 - The Layer FX (LYR_FX) Page; Use Program FX Mode; Layer-Specific FX Mode; Use Another Layers FX Mode

Program Mode
The Layer FX (LYR_FX) Page
6-49
The Layer FX (LYR_FX) Page
Press the LYR_FX soft button to call up the Layer FX (LYR_FX) page. On this page, you can
apply layer-specific effects. There are three Layer FX Modes: Use Program FX, Layer-Specific
FX, and Use Another Layer’s FX.
Use Program FX Mode
With Use Program FX Mode selected, the current layer will use the effects configured on the
Program FX (PROGFX) page. See The Program FX (PROGFX) Page on page 6-46 for more
information on program FX.
Layer-Specific FX Mode
With Layer-Specific FX selected, you can configure the effects for the current layer. This mode’s
parameters are similar to those of the PROGFX page. This mode is shown in the following
display:
All of the Layer-Specific FX mode parameters have the same functions and ranges of values as
their corresponding parameters on the PROGFX page. See The Program FX (PROGFX)
Page on page 6-46 for more information on these parameters.
Use Another Layer’s FX Mode
With Use Another Layer’s FX selected, you can put the current layer through the effects of
another layer. You can specify the layer through whose effects you wish to put the current layer.