MIDI Mode
The TRANSMIT Page
10-1
Chapter 10
MIDI Mode
The PC3 sends and receives MIDI on traditional 5-pin DIN connectors and through USB. MIDI
can be sent and received on all ports at once.
Press the MIDI mode button to enter MIDI mode. There are three pages in MIDI mode:
• TRANSMIT (XMIT soft button)
• RECEIVE (RECV soft button)
• CHANNELS (CHANLS soft button)
You’ll use these pages to determine what MIDI messages the PC3 transmits, and how it
responds to the MIDI messages it receives—as well as how each MIDI channel behaves.
When you enter MIDI mode, you’ll see one of the three available MIDI mode pages.
The TRANSMIT Page
Press the XMIT soft button, and the TRANSMIT page appears. Use the parameters on this page
to control how the PC3 sends MIDI information to its MIDI Out port. These settings to some
extent affect the PC3’s response to its own keyboard and controllers, but they primarily affect
the responses of other MIDI devices that are receiving MIDI from the PC3 on the channel
specified with the Channel parameter on this page.
It’s important to remember that many of the settings of the TRANSMIT page are in effect only
when a program is selected, either in Program mode or in Quick Access mode. If a setup is
selected, in Setup mode or in Quick Access mode, the setup’s MIDI settings override the
corresponding settings on the TRANSMIT page.
To Next Page
Loading...
