Kurzweil PC3 - Start; Stop

Setup Mode
The RIFF2 Page
7-51
Start
Use the Start parameter to specify the riff start point. The time format is Bar : Beat : Tick. Beat can
be set from 1 to 4. Tick can be set from 0 to 959. Since there are 960 possible start points within a
beat, you can specify your riff to start on any common beat subdivision moments (and a few
uncommon ones). The following Tick values correspond to the following beat subdivision
moments:
Stop
Use the Stop parameter to specify the riff stop point. Like the Start parameter, the time format
for Stop is Bar : Beat : Tick. Beat can be set from 1 to 4. Tick can be set from 0 to 959. Refer to
Table 7-6 for Tick values.
The PC3 restricts the selectable values for the Stop parameter such that the current riff is at least
one beat long.
Beat Subdivision
Beat Subdivision
Moment
Tick Value
Quarter note 1st 0
8th note
1st 0
2nd 480
8th note triplet
1st 0
2nd 320
3rd 640
16th note
1st 0
2nd 240
3rd 480
4th 720
16th note quintuplet
1st 0
2nd 192
3rd 384
4th 576
5th 768
16th note triplet (sextuplets)
1st 0
2nd 160
3rd 320
4th 480
5th 640
6th 800
Table 7-6 Subdivision Values