Kurzweil PC3 - The Footswitch Pages (FT SW1, FT SW2, FT SW3)

Setup Mode
The Footswitch Pages (FT SW1, FT SW2, FT SW3)
7-33
The Footswitch Pages (FT SW1, FT SW2, FT SW3)
On the back of the instrument, there are three jacks for Footswitch pedals.
All the foot switches in the default control setup are set to a switch type that doesn’t generate a
note, and consequently the range of values for their respective Destination parameters is the
Control Destination list. There are three Footswitch pages, one for each Footswitch.
The FT SW page parameters are described in Switch Controllers on page 7-21.
Parameter Range of Values Default
Type Momentary, Toggle Momentary
On Control Control Destination List
Ft Sw1: Sustain
Ft Sw2: SostPd
Ft Sw3: SoftPd
On Value None, 0 to 127 127
Off Control Control Destination List
Ft Sw1: Sustain
Ft Sw2: SostPd
Ft Sw3: SoftPd
Off Value None, 0 to 127 0
Entry State None, Off, On None
Exit State None, Off, On None