6-50
Program Mode
The Controllers (CTLS) Page
The Controllers (CTLS) Page
Press the CTLS soft button to call up the Controllers (CTLS) page. The Controllers page is a list
of the controllers on the PC3 you will be most likely to use as control sources and the values of
those controllers. The page appears thusly:
In addition to being able to enter controller values, you can use the SetCtl soft button (located to
the right of the CTLS soft button), which captures the positions of the controllers listed on the
page. Keep in mind that because the controllers are digital, you must engage the controller every
time you change programs before the PC3 recognizes any change in the controller value. If you
change programs, and then press the SetCtl soft button before engaging any of the controllers,
the control values will remain at zero.
The number in parentheses that appears next to the controller name is the MIDI controller
number with which that controller transmits and receives by default, i.e., with the Control Setup
set to 126 Internal Voices on the MIDI mode Transmit page. See Control Setup and Chapter 7:
Setup Mode and Setup Editor for more information on the Control Setup.
Controller Range of Values Default Value
Slider A (6) None, 0-127 0
Slider B (13) None, 0-127 0
Slider C (22) None, 0-127 0
Slider D (23) None, 0-127 0
Slider E (24) None, 0-127 0
Slider F (25) None, 0-127 0
Slider G (26) None, 0-127 0
Slider H (27) None, 0-127 0
Slider I (28) None, 0-127 0
Modwheel (1) None, 0-127 0
Breath Controller (2) None, 0-127 0
Switch 2 (29) 0, 127 0
To Next Page
Loading...
Need help?
General
