Setup Mode
The WHEEL Page
7-29
The WHEEL Page
The two wheels are typical of what is found on many keyboards. The left one is normally used
for pitch bend and springs back to center, while the right wheel is normally used as a standard
Mod Wheel. On the Wheel page in the Setup editor, the pitch wheel has two parameters—one
for pushing the pitch wheel up and one for pushing it down—whereas the mod wheel has one.
The WHEEL page parameters are described in Continuous Controllers on page 7-20.
Parameter Range of Values Default
Destination (PWUp) Control Destination List PitchUp
Destination (PWDn) Control Destination List PitchDwn
Destination (MWhl) Control Destination List MWheel
Scale ± 300% 100%
Add -128 to 127 0
Curve Curve List Linear
Entry Value None, 0 to 127 None
Exit Value None, 0 to 127 None
To Next Page
Loading...
