Kurzweil PC3 - The DSP Modulation (DSPMOD) Page

Program Mode
The DSP Modulation (DSPMOD) Page
6-29
The label of a function-parameter depends on its corresponding function-block in the current
layer’s algorithm. The above DSPCTL page corresponds to the following algorithm:
The DSP Modulation (DSPMOD) Page
Before reading further, be sure to read Algorithm Basics on page 6-13 and Common DSP Control
Parameters on page 6-14.
Press the DSPMOD soft button to call up the DSP Modulation (DSPMOD) page, which is
displayed below:
Each field in the left-hand column of the page is a function-parameter of the current layer’s
algorithm. You can coarsely adjust the function-parameter in these left-hand fields—as noted in
Common DSP Control Parameters, any adjustments made to the function-parameters on the
DSPMOD page are reflected in the corresponding function-parameters on the DSPCTL page.
The right-hand side of the DSPCTL page is the subpage of the highlighted function-parameter—
on the subpage are the programmable parameters. To access the parameters on the subpage,
highlight the function-parameter you wish to edit, and then press the > button to move the
cursor into the subpage.
Parameter Range of Values Default
Source 1 Control Source List Off
Depth (Depends on Function) 0
Source 2 Control Source List Off
Depth Control Control Source List Off
Minimum Depth (Depends on Function) 0
Maximum Depth (Depends on Function) 0