Program Mode
The KEYMAP Page
6-19
The Output Mode parameter determines the number of outputs from the algorithm. With
Output Mode set to Normal, the algorithm has one output. With Output Mode set to Sep. L/R,
the algorithm has two outputs, each of which is sent to a separate stereo channel.
To edit the signal path, select either an input of a block or an output of the entire algorithm. By
scrolling with Alpha Wheel or the - and + buttons, you can see every possible configuration for
that selected signal path.
The KEYMAP Page
Press the KEYMAP soft button to call up the KEYMAP page. The parameters on this page affect
sample root selection, i.e., which samples are played on which keys.
Keymap
Assign keymap from ROM to the current layer. Keymaps are collections of samples assigned to
note and velocity ranges.
Transpose (Xpose)
Transpose the current keymap up as much as 127 semitones (ten octaves and a perfect fifth) or
down as much as 128 semitones (ten octaves and a minor sixth).
Parameter Range of Values Default
Keymap Keymap List 1 Piano f Left
Transpose -128 to 127 semitones 0
Key Tracking ± 2400 cents per key 100
Velocity Tracking ± 7200 cents 0
Alt Method Switched, Continuous Switched
Stereo Off, On Off
Timbre Shift ± 60 semitones 0
Playback Mode Norm, Rvrs, Bidirectional, Noise Normal
Alt Control Control Source List Off
To Next Page
Loading...
