7-30
Setup Mode
The SLIDER and SLID2 Pages
The SLIDER and SLID2 Pages
You can assign each of the PC3’s nine programmable sliders to a destination on each of the 16
zones. Or, you can assign any combination of sliders to the same zone, allowing you tremendous
flexibility. For example, you can assign Sliders A and B to modulate pitch and volume on Zone 1,
then assign Slider C to control panning on Zones 2, 3, and 10.
The SLIDER soft button gives you access to Sliders A–E. Press the SLID2 soft button to program
Sliders F–I. The SLIDER page parameters are described in Continuous Controllers on page 7-20.
Parameter Range of Values Default
Destination (Slider A) Control Destination List Data
Destination (Slider B) Control Destination List MIDI 13
Destination (Slider C) Control Destination List MIDI 22
Destination (Slider D) Control Destination List MIDI 23
Destination (Slider E) Control Destination List MIDI 24
Destination (Slider F) Control Destination List MIDI 25
Destination (Slider G) Control Destination List MIDI 26
Destination (Slider H) Control Destination List MIDI 27
Destination (Slider I) Control Destination List MIDI 28
Scale ±300% 100%
Add -128 to +127 0
Curve Curve List (see text) Linear
Entry Value None, 0 to 127 None
Exit Value None, 0 to 127 None
To Next Page
Loading...
