Setup Mode
Controllers
7-21
Switch Controllers
The Controller Destination List
The table below contains the available values for the Destination parameter for each controller,
in scrolling order. Note that the PC3 has destinations with Controller Numbers greater than
127—there are 127 MIDI Controllers, as dictated by the MIDI spec. Any data sent to destinations
with a Controller number outside of the MIDI range (i.e., more than 127) are sent as a PC3-
specific protocol, and are thus not sent as MIDI data, and not sent through MIDI Out.
Physical Controller
Setup Editor
Page
Parameter:Values
Footswitches 1, 2, and 3
FT SW1,
FT SW2,
FT SW3
SwType: Toggle, Momentary, Note Toggle,
Note Momentary
Destination: Control Destination List
On Value: None, 0 to 127
Off Value: None, 0 to 127
Entry Value: None, Off, On
Exit Value: None, Off, On
Arp and SW switches
ARP SW,
SWITCH
(same as Footswitches)
Programmable switches 1 to 8
SWPRG1,
SWPRG2,
SWPRG3,
SWPRG4,
SWPRG5,
SWPRG6,
SWPRG7,
SWPRG8
(same as Footswitches)
Table 7-4 Switch Controllers
Controller
Number
Corresponding
Destination
Name
Description
0 OFF/Bank By default, when you enter 0 or Clear for the Destination
parameter, the destination will be assigned to OFF. To select
Bank as the destination, use the Alpha Wheel or -/+ buttons.
1 MWheel Default assignment for Mod Wheel
2 Breath Default assignment for CC Pedal 2
3 MIDI 03
4 Foot Default assignment for CC Pedal 1
5 PortTim Monophonic PC3 programs respond to this Controller if
portamento is turned on
6 Data Almost all PC3 programs have this Controller assigned to
filter frequency or brightness
Table 7-5 Controller Destination List
To Next Page
Loading...
