7-52
Setup Mode
The FX Pages: FX, AUXFX1, AUXFX2, and MASTFX
Velocity
This parameter allows you scale the value of the velocities that were recorded in the sequence by
values from 0% to 255%.
The FX Pages: FX, AUXFX1, AUXFX2, and MASTFX
The four Setup mode FX pages—FX, AUXFX1, AUXFX2, and MASTFX—work the same way as
the Effects mode pages—CHANFX, AUXFX1, AUXFX2, and MASTER. See the Effects mode
chapter for information on editing these pages.
The Programmable Switch Pages: SWPRG1 to SWPRG8
The PC3’s eight Programmable Switches are the eight Program Select buttons located above the
program Category buttons. Each button has its own SWPRG page, but each page is essentially
identical.
The SWPRG page parameters are described in Switch Controllers on page 7-21.
The Utility Soft Buttons
In addition to the Setup Editor’s pages, there are basic library and editing soft buttons. Their
functions are described below.
Name
This enables you to rename the current setup. Use any data entry method to do this, including
the letters on the alphanumeric buttonpad.
Parameter Range of Values Default
Type Momentary, Toggled Toggled
On Control Control Destination List OFF
On Value None, 0 to 127 None
Off Control Control Destination List OFF
Off Value None, 0 to 127 None
Entry Value None, Off, On None
Exit Value None, Off, On None
To Next Page
Loading...
