Setup Mode
The Arpeggiator (ARPZON) Page
7-39
Active
The first parameter on the Arpeggiator menu is Active, which specifies whether or not the
Arpeggiator is on for the current zone. This parameter can be switched from the ARPZON page,
or for real-time control, it can be switched on using Controller number 147 (ArpOn) and
switched off using Controller number 148 (ArpOff); these Controllers can, of course, be
assigned as the destination of a PC3 physical controller.
Turning Active on affects zones whose ZoneArpeg values are also set to On. By setting the
ZoneArpeg parameter (on the CH/PRG page) to Off or On in the individual zones of a setup,
you can choose which zones will be controlled by the Arpeggiator when it is on.
Low Key (LoKey) and High Key (HiKey)
The Arpeggiator processes notes within the range of these parameters. Notes outside the
specified range play normally, and do not become part of the arpeggiation sequence. Set the
LoKey and HiKey parameters using the data entry wheel or buttons.
Parameter Range of Values Default
Active On/Off Off
Low Key C -1 to G9 C -1
High Key C -1 to G9 G9
Latch Keys, Overplay, Arpeg, Add, Auto,
Pedals
Keys
Order Played, Upwards, Downwards, UpDown,
UpDown Repeat, Random, Shuffle,
Walking
Played
Beats Quarter Notes, 8th Notes, 8th Triplets,
16th Notes, 16th Triplets, 32nd Notes,
32nd Triplets
16th Notes
Duration 1% to 100% 100%
Note Shift ± 88 Semitones 0
Shift Limit ± 60 24
Limit Option Stop, Reset, Unipolar, Bipolar, Float Res,
Float Uni, Float Bip
Unipolar
Glissando Off, On Off
Velocity Fixed, Played, Last, Bipolar, Aftertouch Played
Simultaneous Off, On Off
To Next Page
Loading...
