MX’er SYSTEM
n After clamping, check each wire to make
sure it is secure.
n Do not squeeze wires against the weld or its
clamp.
n After clamping, check each harness to make
sure that it is not interfering with any moving
or sliding parts.
n When fixing the wire harnesses, do not make
it contact the parts which will generate high
heat.
n Route wire harnesses to avoid sharp edges
or corners. Avoid the projected ends of
bolts and screws.
n Route wire harnesses passing through the
side of bolts and screws. Avoid the
projected ends of bolts and screws.
To Next Page
Loading...
