KYMCO MX’er 125 - Troubleshooting; Battery Removal

14. BATTERY/CHARGING SYSTEM/
A.C. GENERATOR
14
-
3
MX’er SYSTEM
Regulator/Rectifier lock nut 0.7~1.1kgf-m
TESTING INSTRUMENTS
Kowa electric tester
Sanwa electric tester
TROUBLESHOOTING
No power Intermittent power
• Dead battery • Loose battery cable connection
• Disconnected battery cable • Loose charging system connection
• Fuse burned out • Loose connection or short circuit in
• Faulty ignition switch
lighting system
Low power Charging system failure
• Weak battery • Loose, broken or shorted wire or connector
• Loose battery connection • Faulty regulator/rectifier
• Charging system failure • Faulty A.C. generator
• Faulty regulator/rectifier
BATTERY REMOVAL
Pull backward the lock lever, then pull up the
seat at the rear.
Remove the battery by removing the bolt.
First disconnect the battery negative (-) cable
When disconnecting the battery positive (+)
cable, do not touch the frame with tool;
otherwise it will cause short circuit and