MX’er SYSTEM
ENGINE REMOVAL
Drain engine oil and transmission oil.
Remove seat, front cover, center cover, front
fender and rear fender.
Remove the carburetor.
Disconnect the battery negative cable.
Remove the frame body cover.
Disconnect the engine negative cable.
Disconnect the A.C.G. wire connector.
Disconnect the starter motor cable from the
starter relay.
Disconnect the oil recycle tube at the engine
body.
Disconnect the oil recycle tube at the cylinder
head cover.
Loosen the drive belt air cleaner connecting
tube band screw and remove the connecting
tube.
To Next Page
Loading...
