KYMCO MX’er 125 - Swing Arm

13. REAR WHEEL/SWING ARM/
HYDRAULIC BRAKE
13
-
12
MX’er SYSTEM
Install wheel hub, plate washer and nut (wheel
hub).
Torque: 6.0 8.0kgf-m
Install cotter pins.
Install the rear wheel and tighten the nuts
(wheel).
Torque: 6.0 8.0kgf-m
SWING ARM
Place the machine on a level place.
Elevate the rear wheels by placing a suitable
stand under the rear of frame.
Cotter Pin
Axle Nut
Washer
Support the machine securely so there is no
danger of it falling over.
*
Do not loosen the axle nut after torque
tightening. If the axle nut groove id not
aligned with the cotter pin hole, align
groove with the hole by tightening ut on
the axle nut.
*
Always use a new cotter pin.
*
Tapered wheel nuts are used for rear
wheels.
Install the nuts with its tapered side
towards the wheel.
*