KYMCO MX’er 125 - Page 145

12. FRONT WHEEL/FRONT BRAKE/FRONT
SUSPENSION/STEERING SYSTEM
12
-
11
MX’er SYSTEM
Inspect the front arm.
Replace if cracks, bends or damage.
Inspect bushes.
Replace if wear or damage.
INSTALLATION
Reverse the “REMOVAL” procedures.
Install the front arm nut onto the frame and
tighten the nuts.
Torque: 4.0 5.0kgf-m
Apply the grease onto the bush, collars and
covers, then install the steering knuckle onto the
front arm and tighten the nut.
Torque: 4.0 5.0kgf-m
Install the cotter pin and band ends of cotter
pin.
Always use a new cotter pin.
*
Do not attempt to straighten a bent arm,
this may dangerously weaken the arm.
*
Apply the grease onto the bushes, collars
and covers.
*
Bushes