KYMCO MX’er 125 - Page 83

7. CYLINDER HEAD/VALVES
7
-
5
MX’er SYSTEM
washers.
Remove the camshaft holder and dowel pins.
Remove the camshaft gear from the cam chain
and remove the camshaft.
CAMSHAFT INSPECTION
Check each cam lobe for wear or damage.
Measure the cam lobe height.
Service Limits:
IN : 31.40mm replace if below
EX: 31.13mm replace if below
Check each camshaft bearing for play or
Cam Chain
Camshaft Gear
Camshaft Holder
Nut
Washer
D
owel Pins
Camshaft
Diagonally loosen the cylinder head nuts in 2
or 3 times.
*