Kyocera FS-3040MFP - Page 72

2LW/2LX
1-3-44
U620 Setting the remote switching mode
Description
Sets the signal detection method for remote switching. Be sure to change the setting according to
the type of telephone connected to the machine.
Setting
1. Press the start key.
2. Select [REMORT MODE] and press the start key.
3. Select the mode using the cursor up/down keys.
* : Initial setting: ONE
4. Press the start key. The setting is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
U625 Setting the transmission system 1
Description
Makes settings for the auto redialing interval and the number of times of auto redialing.
Purpose
Change the setting to prevent the following problems: fax transmission is not possible due to too
short redial interval, or fax transmission takes too much time to complete due to too long redial
interval.
Method
1. Press the start key.
2. Select the item to be set using the cursor up/down keys.
Setting the auto redialing interval
1. Change the setting using the cursor left/right keys.
2. Press the start key. The value is set.
Item No. Description
Display Description
ONE One-shot detection
CONT Continuous detection
Display Description
INTERVAL Setting the auto redialing interval
TIMES Setting the number of times of auto redialing
Description Setting range Initial setting
Redialing interval 1 to 9 (min.) 3 (120 V)/2 (220-240 V)