Specifying a Destination
39
2
Specifying a Destination
You can specify the destination using
one of four methods.
❖ Fax number
p.39 “Entering a Fax Number”
❖ E-mail address
p.41 “Entering an E-mail Address”
❖ IP-Fax destination
p.43 “Entering an IP-Fax Destina-
tion”
❖ Destination list
p.45 “Using the Destination List to
Specify Single or Group Destina-
tions”
This section covers these functions
and others in more detail.
Note
❒ The display shows the percentage
of free memory space for storing
originals. Since fax numbers and e-
mail addresses are programmed in
separate memory, dialing fax
numbers using the number keys
does not change the percentage on
the display.
Entering a Fax Number
Enter numbers directly using the key
pad on the right side of the control
panel.
Note
❒ Maximum length of a fax number:
128 digits.
❒ You can insert pauses and tones in
a fax number. See p.40 “Pause”,
p.40 “Tone”.
A Enter the fax number using the
number keys.
Note
❒ If you make a mistake, press the
{Clear/Stop} key, and then enter
again.
❒ If the optional extra G3 interface
unit is installed, select G3 before
pressing the {Start} key. See
p.60 “Changing the Line Port”,
Facsimile Reference <Advanced
Features> .
❒ Press [ProgDest] after entering
the fax number to store the fax
number in the destination list.
See p.45 “Registering Entered
Destinations to the Address
Book”.
RussianC4-EN_Combine-F_FM.book Page 39 Wednesday, April 27, 2005 2:01 PM
To Next Page
Loading...
