Safety Decals Care
• Keep safety decals and signs clean and legible at all
times.
• Become familiar with the content and position of each
safety decal. Decals include important information.
• Replace decals and signs that are missing or become
impossible to read.
• When replacing parts that display a safety decal,
ensure that the new part is tted with a decal as well.
• Obtain safety decals or signs from your authorized
LeeBoy dealer.
Decal Installation (Sticker Type)
1. Be sure that the installation area is clean and dry.
Use hot, soapy water to clean the surface where the
decal will be applied. Thoroughly dry the surface.
2. Measure and test tting before removing the decal
paper backing to position.
3. Align the decal over the specied area and carefully
press exposed portion into place.
4. Slowly remove the remaining backing and carefully
smooth the remaining portion of the decal into place.
5. Small air pockets can be pierced with a pin and
smoothed using a piece of the decal backing.
Decal Installation (Top
Protected)
1. If the decal has a protective top paper, use hot
soapy water on the surface where the decal will be
applied. Leave wet.
2. After determining the correct decal location, remove
the protective back paper and soak decal in clean,
soapy water before application. This will help to
alleviate air bubbles in the applied decal.
3. Smooth the decal into place with a squeegee and
check for air bubbles.
4. Small air pockets can be pierced with a pin and
smoothed using a piece of the decal backing.
5. When the decal is completely smooth, carefully
remove the top paper.
1
3000C Force Feed Loader 1-9
To Next Page
Loading...