MAINTENANCE SCHEDULE
Before performing any maintenance procedures on the
LeeBoy 3000C Force Feed Loader, read the following
safety information and review Safety in Section 2.
Tool Hazard! ALWAYS use tools
appropriate for the task. Be sure to use the correct
sized tool for loosening or tightening parts.
Follow all maintenance schedules and procedures
to maintain the machine in top operating order. The
maintenance schedule begins with 10-hour, or daily,
maintenance intervals and continues through the 1000-
hour, or annual, maintenance schedule intervals.
NOTE: When performing any routine maintenance,
always include previous routine
maintenance procedures to the higher
hourly schedule.
Preventive maintenance on the loader will provide
years of trouble-free operation. Adjustments can be
performed in the eld with ordinary tools.
Engine preventive maintenance, (other than oil, air
and fuel lter changes), can be found in the Engine
Operator’s Manual.
Anytime the loader has been repainted or the decals
removed, damaged or illegible, replace immediately for
safe operation.
Changing oil and cleaning the loader
should only be done in a designated area where the
the oil and chemicals can be contained. These by-
products should be discarded in accordance with
environmental regulations.
Failure to observe the operating
precautions and warning instructions provided in
this manual can cause serious injury or death. Only
authorized personnel who are properly trained
should operate the LeeBoy Model 3000C Force
Feed Loader.
Do not operate a machine that is
in need of repair. Put an information tag on the
instrument panel that says “DO NOT OPERATE”
and remove key from the ignition switch. Repair all
damage promptly as even minor damage can result
in major system failures.
NOTE: If the machine is operated more than 10
hours per day, follow the “Hour” schedules.
If the machine is operated less than 10 hours
per day, follow the “Periodic” schedules.
10-Hour or Daily Routine
Maintenance
1. Check engine oil. Add more if needed. (Page 5-8)
2. Check coolant level. Add more if needed. (Page
5-7)
3. Check air lter indicator. Clean or replace if
indicator is red. (Page 5-10)
4. Check hydraulic oil level. Add more if needed.
(Page 5-14)
5. Check battery cables and connectors. (Page 5-17)
6. Check conveyor belt alignment. (Page 4-12)
7. Check hydraulic hoses for leaks and wear.
50-Hour Routine Maintenance
The LeeBoy 3000C Force
Feed Loader hydraulic system requires clean,
contaminant-free oil. Be careful working with the
hydraulic system to ensure it is completely clean.
1. Perform previous maintenance procedures.
2. Lubricate machine. (Page 5-6)
3. Inspect fuel system and clamps. (Page 5-13)
4. Perform any other engine preventative maintenance
as described in the Engine Operator’s Manual.
100-Hour or Monthly Routine
Maintenance
1. Perform previous maintenance procedures.
2. Inspect air intake hoses and clamps.
3. Check for loose, missing, damaged or corroded
parts. Repair or replace as necessary.
4. Check pump drive gear oil. Add more if needed.
(Page 5-16)
5. Change engine oil and oil lter. (Page 5-9)
6. Perform any other engine preventative maintenance
as described in the Engine Operator’s Manual.
7. Check tire pressure. (Page 5-7)
Maintenance
3000C Force Feed Loader5-4
To Next Page
Loading...