LeeBoy 3000C - Tire Precautions; Starting and Stopping Precautions; Parking Precautions

Tire Precautions
DO NOT mount or demount tires
without proper training. A violent explosion can
occur.
Follow all procedures and safety instructions. Wall
charts containing mounting and demounting instructions
for all rims are available through the United States
Department of Transportation (DOT), Washington, D.C.
When in doubt, contact a qualied
tire dealer or repair service to perform required tire
maintenance.
Inspection
• Clean rims and repaint to stop detrimental effects of
corrosion and facilitate checking and tire mounting.
• Be very careful to clean all dirt and rust from rims.
This is important for securing rims into the proper
position.
• Check rim components periodically for cracks.
Replace all cracked, badly worn, severely rusted, and
otherwise damaged components with new parts of the
same size and type. If you are not sure about proper
mating of tire and wheel parts, consult a wheel and rim
expert.
DO NOT attempt to rework, weld,
heat or braze any rim components that are cracked,
broken or damaged. Replace damaged components
with new parts of the same size and type. Mixing
parts of one type with those of another is potentially
dangerous.
DO NOT reinate a at tire without
rst inspecting the tire, tube, ap, rim, and wheel
assembly for damage. Be sure parts are secured
before ination.
Starting and Stopping
Precautions
• Check all around loader to make sure there are no
people working on the machine or in the path of the
machine before starting. DO NOT start until area is
clear. Death or serious injury can occur to bystanders
from being crushed under a moving machine.
Check brakes, steering and other
control devices in accordance with instructions
before starting. Be sure parking brake is applied and
the direction control lever is in neutral.
• Latch seat belt (if equipped) and adjust to t snugly.
• Only start and operate the machine from the
operator’s seat. DO NOT bypass the neutral-start
system. If the system malfunctions, it must be
repaired.
DO NOT operate the engine in an
enclosed area without proper ventillation. Exhaust
gasses are odorless and deadly.
Parking Precautions
• Park the machine on level ground whenever possible.
On grades, park with wheels securely blocked.
Always apply parking brake.
• Before leaving operator’s station:
1. Place Forward/Reverse lever in neutral.
2. Turn off all accessories.
3. Set parking brake.
4. Shut off engine.
• Always remove ignition key when leaving the loader
parked or unattended.
1
3000C Force Feed Loader 1-11