250-Hour or Quarterly Routine
Maintenance
1. Perform previous maintenance procedures.
2. Replace fuel lters. (Page 5-13)
3. Replace hydraulic oil lter. (Page 5-16)
4. Inspect engine drive belt. Replace if needed. (Page
5-10)
5. Check for damaged, loose, or missing decals.
Replace decals as required. (Page 1-8)
6. Check differential oil level. Add more if needed.
(Page 5-16)
7. Check planetary hub uid level. Add more if needed.
(Page 5-17)
8. Service battery. (Page 5-17)
9. Inspect coolant hoses and clamps. (Page 5-7)
10. Perform any other engine preventative maintenance
as described in the Engine Operator’s Manual.
500-Hour or Semi-Annual
Routine Maintenance
1. Perform previous maintenance procedures.
1. All bearings are sealed and have grease ttings.
These should be greased with multipurpose grease
using a grease gun. (Page 5-6)
2. Replace air lter. (Page 5-10)
3. Perform any other engine preventative maintenance
as described in the Engine Operator’s Manual.
1000-Hour or Annual Routine
Maintenance
1. Drain and ush the hydraulic tank. A drain plug
is located on the bottom of the tank for this
purpose. Clean the strainer screens in the tank.
The recommended hydraulic oil is Citgo All-Temp.
(Page 5-15)
2. Perform the 1,000-hour preventative maintenance
as described in the Engine Operator’s Manual.
3. Check for damaged, loose, or missing decals.
Replace decals immediately for operator safety.
(Page 1-8)
4. Perform any other engine preventative maintenance
as described in the Engine Operator’s Manual.
2000-Hour or Annual Routine
Maintenance
1. Inspect the Diesel Exhuast Fluid (DEF) lter. Clean
or replace if needed. (Page 5-12)
2. Perform any other engine preventative maintenance
as described in the Engine Operator’s Manual.
3000-Hour or Annual Routine
Maintenance
1. Inspect the DEF Supply Module Filter. Clean or
replace if needed. (Page 5-12)
2. Perform any other engine preventative maintenance
as described in the Engine Operator’s Manual.
5
Maintenance
3000C Force Feed Loader 5-5
To Next Page
Loading...