GENERAL INFORMATION
This section gives the necessary procedures for routine
and general maintenance on the LeeBoy 3000C Force
Feed Loader. Keep the loader clean and follow all
maintenance schedules and procedures to maintain the
machine in top operating condition.
Maintenance must be a planned program that
includes periodic machine inspection and lubrication
procedures. The operator should inspect the machine
daily. Worn or damaged parts should be replaced or
repaired promptly to prevent damage to other areas of
the machine. Daily inspections should include checking
for loose bolts, uid leaks, worn or damaged hoses, and
debris or dirt accumulations to prevent potential service
or safety problems.
The maintenance program should be done based on the
machine “Operating Hours” recorded on the hour meter
or by following the Periodic Schedule shown below.
Table 1-1.Periodic Maintenance Schedule
SYSTEM ITEM
Every
10 Hours
Every
50 Hours
Every
100 Hours
Every
250 Hours
Every
500 Hours
Every
1000 Hours
Loader Lubricate machine. X
Conveyor Check conveyor belt alignment. X
Hydraulic
Check 2-Speed gear box oil level. X
Check planetary hub gear oil level. X
Inspect hydraulic hoses. X
Replace hydraulic oil charge lter cartridge. X
Check hydraulic oil level. X
Change hydraulic oil. X
Check pump drive gear oil. X
Check differential oil level. X
Engine
Inspect belts, replace if needed. X
Inspect air intake hoses and clamps. X
Inspect alternator and connections. X
Replace engine oil and oil lter cartridge. X
Check oil level - change at initial 50 hours. X
Check air cleaner indicator. Clean and
replace if indicator is red.
X
Change crankcase ventilation lter. X
Electrical
Inspect battery cables and connections. X
Service battery. X
Fuel
Replace fuel lter cartridge. X
Inspect fuel system hoses and clamps. X
Cooling
Check coolant level. Fill if needed. X
Inspect coolant hoses and clamps. X
DEF
Diesel Exhaust Fluid (DEF) Tank Filter
Inspect every 2000 hours (or 2 years). Clean or
replace if needed.
DEF Supply Module Filter
Inspect every 4500 hours (or 3 years). Clean or
replace if needed.
5
Maintenance
3000C Force Feed Loader 5-3
To Next Page
Loading...