OPERATING PRECAUTIONS
• Always comply with local regulations regarding
moving equipment on public roads and highways.
• Know and use the hand signals required for a
particular job. Know who has the responsibility for
signaling.
• Make sure all lights and reectors comply with state
and local regulations. Keep them clean and in good
working order so they can be seen clearly by all trafc.
DO NOT stand between the equipment
and the truck while the truck is being coupled
with the force feed loader. Death or serious injury
can result from being crushed between the two
machines. DO NOT ride on attachments.
Some work situations require
more attention to stopping distances, particularly
when going downhill. The larger the force feed
loader, the more it will slide on a slippery surface.
Steeper grades require longer stopping distances.
Familiarize yourself with these variables so you
can anticipate when longer stopping distances are
required.
• Check all gauges and warning instruments for proper
operation. If malfunctions are found, shut down the
machine and report the problem. If the failure causes
loss of steering control, loss of brake control or loss
of engine power, stop machine motion as quickly as
possible. Apply parking brake and keep the machine
securely parked until the failure is corrected or the
machine can be safely towed.
• DO NOT operate unit when warning buzzer/light is
illuminated.
• Drive the machine with care. Make sure speed is
compatible with conditions. Use caution on rough
ground, slopes and while turning.
• Be alert for hazards and obstructions such as ditches,
trees, cliffs, overhead power lines, and areas where
there is danger of a slide.
• Be aware and understand the job site trafc ow
patterns.
• Obey agmen, road signs and signals.
• Watch for bystanders. Never allow anyone to be
under the machine during operation. Never allow
anyone to reach into the machine during use.
• Operator must know how to use signaling devices
when roading the machine. Operator must also
understand which circumstances require use of each
signal. Use tail lights, slow moving vehicle signs, and
warning beacon as needed when traveling on public
roads.
• When required, provide an escort for roading.
• DO NOT tow the machine, except to remove from road
or to load on trailer.
MAINTENANCE PRECAUTIONS
• DO NOT attempt repairs unless trained to do so.
Refer to manuals and experienced repair personnel
for help.
• Before conducting maintenance, securely block the
machine and any components that may fall. Block
any working components to prevent unexpected
movement while repairs are being made.
• Always wear safety glasses and other required safety
equipment when servicing or making repairs.
• Disconnect battery before working on the electrical
system.
• Avoid lubrication or mechanical adjustments while the
machine is in motion or while engine is operating. If
lubrication or mechanical adjustment is necessary:
1. Place Forward/Reverse control in neutral.
2. Apply parking brake.
3. Shut off engine.
4. Place equipment in a safe position.
5. Securely block wheels.
6. Use extreme caution.
• Never make repairs on pressurized components such
as uid lines, the gas system or mechanical items until
the pressure has been relieved.
• Keep brake and steering systems in good operating
condition.
3000C Force Feed Loader1-12
To Next Page
Loading...