39
24/09/2013
+ =
0672 64
HA/HB4599
L/N4599N
078428
079128
663097
665111
Saving of the PRESET position (opening the rolling shutter to a preset position)
In addition to the operating modes specified, this device can be used to also set the
rolling shutters to a preset position by only pressing one pushbutton.
The procedure is performed in two different stages:
- calibration of the up and down movements times of the rolling shutter;
- saving of their positions.
Calibration of the up and down movements times of the rolling shutter;
1. Check if the rolling shutter motor is equipped with a traditional, or with an electronic
“limit switch”.
2. Fully open the rolling shutter.
3. In case of traditional limit switch, press the pushbutton shown in the picture for more
than 4 seconds. Press the pushbutton for less than 1 second in case of electronic limit
switch.
4. The rolling shutter will close completely, will open completely, and then will move to
the half open position. During this stage do not operate the device.
5. The device has saved the rolling shutter full opening and full closing time. Now proceed
with saving the desired position (Preset).
Saving the rolling shutter position:
1. Operate the UP and DOWN PUShbuttons of the radio control to move the rolling
shutter to the desired position.
2. To save the desired position press the Preset pushbutton of the rolling shutter radio
control for more than 10 seconds.
3. From now on, irrespective of its position, when the Preset pushbutton of the
control device is pressed the rolling shutter will move to the previously saved
position.
< 1 sec.
> 4 sec.
Shutter control RF
MQ00409-c-EN
> 10 sec.
To Next Page
Loading...
