Group 9 Equipping/maintenance Page 147
Release 3.00 Leibinger-Jet 2 se
The spindle (1) and the guides (2) of the nozzle seal should be cleaned at least once
per week with the corresponding solvent.
Figure 111
1 – Spindle
2 – Guides
9.4.3 Other cleaning work
9.4.3.1 Cleaning the nozzle
Dangerous electrical voltage!
Contact causes serious damage through an electric shock!
Disconnect the device from the mains supply prior to opening.
Remove mains plug!
Risk of fire!
Combustible gases and liquids cause serious burns. Sources of
ignition must be kept away from the print head!
Risk of injury!
Ink escapes from the head aperture. Spraying of ink into the eyes
can cause blindness. Eye protection is necessary!
Risk of injury!
Upon contact the contents causes skin irritation. Protective
equipment is necessary!
This work must only be carried out by trained personnel or by
Leibinger service technicians!
1
2
To Next Page
Loading...
