Leibinger Jet 2 - Factory Setting & Default Jobs

Group 7 Data Entry Page 87
Release 3.00 Leibinger-Jet 2 se
7.3.2 Factory setting & default jobs
Figure 60
The touch field <factory setting & default
job> (65) resets the device to the standard
settings and a default job i.e. type
height/width, bar code and print start
parameters are reset, is then loaded into
the working storage.
If all jobs deposited have been deleted in advance then all jobs (up to “E”) will
automatically be loaded as illustrated in the job administration menu <E45> (main menu
– jobs menu – load job).
[E5]
65