Leica LS10 - Page 50

PtID: Enter a point ID with 16 characters maximum. The point ID can consist
of numeric and alphanumeric characters. If the point ID ends with an alphanu-
meric character, the sufx “01” is added automatically after returning to one
of the levelling applications.
Incr: Enter an increment of maximum 9999. This input eld is limited to four
numeric characters.
Indiv.PtID: Choose whether the individual point ID is to be applied once or
permanently.
•
Use once: This is the default value. If selected, the individual point ID is
only applied once to the next point measured. To all following points, the
next running point ID and its dened incrementation are applied.
•
Use permanent: If selected, the individual point ID and its dened incre-
mentation are applied permanently to all following points measured.
☞
The Indiv.PtID: function is also available for surveying intermediate
points. Exception: the point ID of the rst intermediate point is
always “1001” by default.
Sometimes it is necessary to measure special points within a line and desig-
nate them with an individual point ID. To avoid retyping and incrementing the
point ID manually for each special point, use the Next indiv PtID function.
1. In the Point ID & Incrementation menu, dene a default point ID
and incrementation to be used for the next measurement task.
Make sure that the function Indiv.PtID: is set to Use once. Refer to
Dene a default point ID and incrementation (within 7.1.3 Point ID
& Incrementation).
2. If not already done, assign the option Next indiv PtID to one of the
user keys. Refer to 6.1 Work Settings.
3. Open a levelling application and start measuring points. The dened
default point ID is applied to the measured points.
4. To apply an individual point ID, enter the desired ID into the
Foresight Pt eld before measuring a special point.
The entered point ID is applied to the next point measured. To all
following points, the running point ID is applied again.
5. When measuring another special point, press the respective user
key.
The previously entered individual point ID is automatically entered
into the Foresight Pt eld and incremented. To all following points,
the running point ID is applied again.
6. Repeat the process as desired.
Apply an individual
point ID during meas-
urements
50 Programs